Engine Oil Priming Kit Prime the oil system before the first start-up of a freshly built, rebuilt or long-stored engine with this complete 12V engine oil priming kit. The kit is designed to circulate oil through the engine before start-up, helping prime the oil system and hydraulic lifters. It can also be used for oil-transfer applications, such as removing oil from engines including ski boats. What’s Included 12V oil pump Oil filter Fittings Hose Clamps Setup instructions Pump Specifications Approximate flow rate: 4 L/min Operating pressure: approximately 40–50 psi Designed to operate as part of a recirculating oil-priming setup Basic Setup Connect the black fitting to the sump-plug hole. Install the metal adapter into the oil-pressure switch port. Install the supplied oil filter between the pump and engine. Connect the hoses and fittings according to the supplied instructions. Run the priming system to circulate oil through the engine before start-up. Optional Oil Pressure Gauge An optional 1/8-inch pressure gauge setup can be added if you want to monitor oil pressure while priming. The existing Boost Doc setup references a Turbosmart fuel-pressure gauge and brass T-fitting for this purpose. Important Operating Information The pump is air-cooled and should not be operated continuously for more than 10–12 minutes at a time. Before use: Clean and inspect all components Check that all fittings and hoses are securely connected Confirm the oil-flow path before operating the pump Follow the supplied setup instructions carefully It is the user’s responsibility to clean and inspect all components before use. Suitable Applications This kit is useful for: Freshly built engines Rebuilt engines Engines that have been sitting unused for extended periods Priming hydraulic lifters Circulating oil before initial start-up Oil-transfer or oil-removal applications Prime your engine’s oil system before first start-up with a complete 12V oil priming setup.