Tiny Touch Plate V1. The Touch Plate is 0.5mm thick stainless steel. It has nice flex to it but it can be bent if you would prefer a little angle to it. The Kit Comes with; 1- Stainless Steel 0.5mm thick touch plate 1- Wire, 2M (80"), 22AWG with a female dupont plug on one end already. Premium Silicone 1- Alligator clamp, easily handle 1/8" to 1/4" endmills, Copper or Steel. 1- Molex brand Spade connector. 1-1/8 in x 1/2 in (3.15mmx12.6mm) Neodymium Cylinder N52 (ND004) Magnet This is a DIY bag of parts because I know you all like to personalize things. Cut and crimp the wire to a length suitable for your build. The Refill Comes with; 1- Stainless Steel 0.5mm thick touch plate Use: The alligator clip should be connected to the Zmin negative, and the plate to the S (signal) pin. The clip and the plate should be stored in contact with each other, to prevent Static discharge issues. All V1 Firmware is and has been ready to use this type of plate. Further details and machine specific Gcode can be found on the Milling Basics page. Quick clip of it in use. Changelog- Update starting with order #28626, 2M cable (twice as long, and stronger N52 magnet.
